Rubber Grips for BMW HP2 Enduro & HP2 Megamoto

BMW HP2 Enduro & HP2 Megamoto Bikes

BMW R1200GS (04-12), R1200GS Adv (05-13) & HP2 Rubber Grips

Our rubber grips improve the rider's feeling and safety. They reduce vibration and are made of an outstanding material quality. They are resistant to weathering, UV and ozone.
Sold in pairs.
Length: 125 mm.
Diameter: 24,5-26 / 22-24 mm
Close-ended grip, not compatible with handlebar end weights.

Caution: These rubber grips only fit motorcycles without heated grips!

Note: These rubber grips also fit for BMW C1.

The mounting of the rubber grips is not easy, especially on motorcycles with heated grips. In the event of improper handling, the heated grips can be damaged / cut through when removing the old rubber grips. This danger exists especially with fully glued rubber grips. The replacement of the rubber grips is at your own risk. We accept no liability for any damage to the motorcycle. If in doubt, please have the rubber grips replaced by a specialist workshop.

There is a video for this product - watch here!

Rubber Grips, 2 pieces (24,5-26mm / 22-24mm)

Article-No. : 0720855

Availability: immediately available Show details

Price: € 32,90
USD: 35,34 $
GBP: 28,32 £
AUD: 53,87 $A
without VAT plus shipping

Questions about this article

How do I install the rubber grips when I have heated grips?
The installation is not easy. If you can't do it or have no experience in it, please go to a professional repair shop.
You have to cut the original grips from the heating.
Which is no big problem but you have to be careful!
Then you can put the new grips in boiling water to enlarge them.
Then of course dry them. Push them over the grip. That’s it.

Please make also sure that you order the correct grips.
You can find all sizes in the product description.
If you install too small grips they will of course crack!